User's Guide

Index
Help
Safety
Contents

Installing Components and Setting Up the Network Interface

Overview

This section describes the general procedure on how to set up the network interface for use on a network.

Check the network interface operation.

Check the functions and operations of the network interface, such as status lights, status sheet button, and the RJ-45 connector. See Network Interface Operation for details.

Select a printing method.

Select a printing method appropriate for your network environment and operating system. If you are not sure, see Printing from Windows or Printing from Macintosh for details.

Install the necessary components on the computer.

Make sure the necessary components (such as TCP/IP, NetBEUI, etc.) are installed on the computer, and network settings (such as the IP address, subnet mask, etc.) of the computer are set. See About Installing Components on Your Computer for details.

If necessary, install the printer driver.

Install the printer driver from the CD-ROM that comes with the device. See About Installing the Printer Driver for details.

Install the network interface on the device.

Install the network interface and initialize it. See Installing the Network Interface on the Device.

Insert the Software CD-ROM in the CD-ROM drive to configure the network interface

Connect the network interface to the network. For Windows users, see Configuring the network interface for Windows for details. For Macintosh users, see Configuring the network interface for Macintosh for details.

If necessary, modify the network settings of the network interface using EpsonNet Config.

Modify the network interface for TCP/IP, AppleTalk, MS Network, etc. using EpsonNet Config. For Windows users, see About EpsonNet Config for Windows for details. For Macintosh users, see About EpsonNet Config for Macintosh.


[Top]


Next
Version 1.00E, Copyright © 2003, SEIKO EPSON CORPORATION