Reference Guide

Index	Help	Safety

Contents	Glossary

How To

Overview

This section describes the general procedure on how to set up the network interface for use on a network.

Check the network interface operation.

Check the functions and operations of the network interface, such as status lights, status sheet button, USB connector, DC-IN connector, and security lock. See Network Interface Operation for details.

Select a printing method.

Select a printing method appropriate for your network environment and operating system. If you are not sure, see Printing from Windows or Printing from Macintosh for details.

Install the necessary components on your computer.

Make sure the necessary components (such as TCP/IP, NetBEUI, etc.) are installed on the computer, and network settings (such as IP address, subnet mask, etc.) of the computer is set. See About Installing Components on Your Computer for details.

Insert the Software CD-ROM in the CD-ROM drive to configure the network interface.

If you are using one of the following Epson devices, see For Windows or For Macintosh for details.

- EPSON STYLUS PHOTO RX500
- EPSON STYLUS PHOTO RX600
- EPSON STYLUS CX4600
- EPSON STYLUS CX6400
- EPSON STYLUS CX6600

If your device is not listed above, see For Windows or For Macintosh for details.

If necessary, install the printer driver.

Install the printer driver from the CD-ROM that comes with the device. See About Installing the Printer Driver for details.

If necessary, configure the network settings of the network interface using EpsonNet Config.

Configure the network interface for TCP/IP, AppleTalk, MS Network, etc. using EpsonNet Config. For Windows users, see About EpsonNet Config. For Macintosh users, see About EpsonNet Config.

[Top]