If you have problems with automatic adjustments not being applied correctly, try the following solutions:
Be sure to wait at least 30 minutes after turning on the projector before performing automatic adjustments. This gives the projector's temperature a chance to stabilize.
Check that the camera area is clean.
Make sure the cable of the optional external camera is securely connected to the projector.
The optional external camera may be defective. Contact Epson for help.
Make sure that a powerful spotlight or source of strong natural light is not shining into the projection environment and interfering with automatic adjustments.
Check that your image correction and image blending settings are within reasonable ranges. If the projection angle is very large, try turning off the Geometry Correction setting or reduce the projection angle. If you are using the Edge Blending setting, make sure the blending width is between 15 to 43%.
If you see an error message during automatic adjustments, check the error codes in the message.
During Screen Matching:
0101: Measurement value error
0102: Measurement failure
0103: Switch camera failure
0104/0105: Model mismatch
0108: Camera error
During Color Matching:
0201: Measurement value error
0202: Measurement failure
0203: Switch camera failure
0208: Camera error
Contact Epson for support for details.